D81C55HC-2 2k RAM With I/O and Timer ICs

550৳ 
The D81C55HC-2 is a 2k-bit static RAM (256 bytes) with parallel I/O ports and a timer. It uses silicon gate CMOS technology and consumes a standby current of 100 micro ampere, maximum, while the chip is not selected.

RF9640 200V 11A P-Channel Power MOSFET

87৳ 
The IRF9640 is a 200V 11A Fifth Generation P-Channel HEXFETs from International Rectifier utilize advanced processing techniques to achieve extremely low on-resistance per silicon area. This benefit, combined with the fast switching speed and ruggedized.

BS170 60V 500mA N-Channel Switching MOSFET

25৳ 
The BS170 is an N−Channel enhancement mode field effect transistors are produced using ON Semiconductor proprietary, high cell density, DMOS technology.

HA17339A Quadruple Comparator IC (Renesas)

76৳ 
The HA17339A is comparators designed for use in power or control systems. Its operate from a single power-supply voltage over a wide range of voltages, and feature a reduced power-supply current since the power-supply voltage is determined independently.

LM2596HVS High Voltage Step Down or Buck Module

180৳ 
The LM2596HVS is a High-voltage input version of the LM2596S low-cost high-amperage switch mode DC/DC Buck power supply module. The module can accept up to 60V input voltage. Get any voltage between 4.5V to 35V.

2SC3039 400V 7A NPN Switching Transistor

35৳ 
The 2SC3039, 2SC-3039, 3039 is a 400V 7A NPN Triple Diffused Planar Silicon Transistor, TO-220 Package. This Product manufactured by Sanyo-Japan.

MT3608 DC-2-28V 2A Boost Converter (Step Up)

85৳ 
The MT3608 Step-up converter (Output voltage higher than input). Supply voltage 2-28V, output max. 28V at max 2A. Avoid the state when the input terminals have higher voltages than those set on the output terminals. The drive chip may be damaged.

BC557 45V 100mA PNP General Purpose Transistor

3৳ 
The BC557 has a gain value of 110 to 800, this value determines the amplification capacity of the transistor. The maximum amount of current that could flow through the Collector pin is 100mA, hence we cannot connect loads that consume more than 100mA usin