ENC28J60-I/SO Ethernet Controller IC With SPI
330৳
The ENC28J60-I/SO is a standalone Ethernet controller with an industry standard Serial Peripheral Interface (SPI™). It is designed to serve as an Ethernet network interface for any microcontroller equipped with SPI Communication.
Categories: Components & IC, General IC
Tag: ENC28J60-I/SO Ethernet Controller IC With SPI
Description
The ENC28J60-I/SO is a standalone Ethernet controller with an industry standard Serial Peripheral Interface (SPI™). It is designed to serve as an Ethernet network interface for any microcontroller equipped with SPI Communication. The microcontroller is implemented via SPI, with data rates up to 10Mbit/s.
Features:
- IEEE 802.3ô Compatible Ethernet Controller
- Fully Compatible with 10/100/1000Base-T Networks
- Integrated MAC and 10Base-T PHY
- Supports One 10Base-T Port with Automatic
- Polarity Detection and Correction
- Supports Full and Half-Duplex modes
- Programmable Automatic Retransmit on Collision
- Programmable Padding and CRC Generation
- Programmable Automatic Rejection of Erroneous Packets
- SPI Interface with Clock Speeds Up to 20 MHz
Buffer’s:
- 8-Kbyte Transmit/Receive Packet Dual Port SRAM
- Configurable Transmit/Receive Buffer Size
- Hardware Managed Circular Receive FIFO
- Byte-Wide Random and Sequential Access with Auto-Increment
- Internal DMA for Fast Data Movement
- Hardware Assisted Checksum Calculation for
- Various Network Protocols
Medium Access Controller Features:
- Supports Unicast, Multicast and Broadcast Packets
- Programmable Receive Packet Filtering and Wake-up
- Host on Logical AND or OR of the Following:
- Unicast destination address
- Multicast address
- Broadcast address
- Magic Packet
- Group destination addresses as defined by
- 64-bit Hash Table
- Programmable Pattern Matching of up to
- 64 bytes at user-defined offset
Physical Layer Features:
- Loopback mode
- Two Programmable LED Outputs for LINK, TX,
- RX, Collision and Full/Half-Duplex Status
Operational:
- Six Interrupt Sources and One Interrupt Output Pin
- 25 MHz Clock Input Requirement
- Clock Out Pin with Programmable Prescaler
- Operating Voltage of 3.1V to 3.6V (3.3V typical)
- 5V Tolerant Inputs
- Temperature Range: -40°C to +85°C Industrial, 0°C to +70°C Commercial (SSOP only)
- 28-Pin SPDIP, SSOP, SOIC, QFN Packages
Packing List:
1Pc * ENC28J60-I/SO Ethernet Controller IC With SPI
Reviews (0)
Be the first to review “ENC28J60-I/SO Ethernet Controller IC With SPI” Cancel reply
Related products
2N2369A 15V 100mA NPN (BJT) Transistor
80৳
2N3904 60V 200mA NPN General Purpose Transistor
3৳
2N3906 40V 200mA PNP General Purpose Transistor
3৳
2N5401 Bipolar Transistor PNP SOT-23
10৳
2SA1266 50V 150mA PNP Bipolar Transistor
5৳
2SC2073 150V 1.5A (BJT) NPN Transistor
25৳
LM2937T-5 5V 500mA Low Dropout Regulator IC
80৳
LT1083 Adjustable Voltage Regulator
1145৳

Reviews
There are no reviews yet.